If you're unsure of how to install or remove plug-ins, check the Plug-in section of the manual: http://www.inklen.com/mixemergency/manual/plugins/
New plug-ins can be downloaded from: http://www.inklen.com/mixemergency/plugins/
In the coming weeks we will be releasing new plug-ins every week as our "Plug-in of the Week!".
Comments
Zoom Fade is a transition that zooms in the outgoing channel while fading in the incoming channel.
Parameter 1: The amount that the outgoing channel is scaled, allowing you to create anything between gentle and dramatic transitions.
Flip Strips H is a transition that flips a number of 3D segments horizontally.
Parameter 1: The number of strips.
Spectrum Smooth Mask is an effect that masks the output with the current audio spectrum for the channel.
Parameter 1: Adjusts the audio spectrum gain.
Parameter 2: Offset of the audio spectrum mask.
Scale H is a transition effect that scales the incoming and outgoing channels relative to their current mix. The scaling maintains the aspect ratio of both channels. One advantage of this type of transition is that the full output of both channels is visible on screen at once.
Reflective Swap is a transition effect that rotates and moves the outgoing channel back, while bringing forward the incoming channel. Each channel has an added reflection to create the illusion of the channels sitting on a shiny surface.
Parameter 1: Controls the perspective.
Two Up H is a transition effect that allows both channels to be visible at the same time. It does this by scaling and cropping each channel.
Parameter 1: Scale.
Spectrum 3D Surface is a channel effect that warps a 3D surface by an amount determined by the spectral analysis of the currently playing media.
Parameter 1: The amount that the surface is warped by.
Parameter 2: Controls the direction in which the spectrum is applied to the surface.
Push Warp H is a transition effect similar to the Slide transition - but with a twist.
Parameter 1: Adjusts the intensity of the warping.
Wipe Out V is a transition effect that performs a wipe transition that starts in the center and moves outwards vertically.
Parameter 1: Adjusts the edges of the Wipe effect between sharp and smooth.
Blur is a channel effect that applies a Gaussian blur to the soruce.
Parameter 1: Adjusts the amount of blur.
Grid 3x3 Sequenced is a transition effect that similar to the Grid effects in MixEmergency. Unlike the previous Grid effects, Grid 3x3 Sequenced uses one of seven pre-defined grid patterns that can be selected using the transition parameter control.
Parameter 1: Selects the preset grid sequence.
Delay is a channel effect that allows you to delay the video output.
Parameter 1: The delay time. At the maximum setting the delay is half a second.
Parameter 2: The first half controls the dissolve amount between the original video and the delayed video. The second half of the Parameter 2 control allows you to change between four extra blend modes.
Center Slide H is a transition effect that is a combination of a Slide and Wipe transition. This allows the center (often the focus) of both videos to be displayed during the transition.
Fall Back is a transition effect that reduces the scale and rotates the current outgoing image.
Parameter 1: Adjusts the amount of rotation applied during the transition.
Grid Flip is a transition effect that separates the outgoing channel into a number of squares and flips them to reveal the incoming channel. The flip order is randomly assigned each time the transition completes a transition from one side to the another.
Parameter 1: Adjusts the number of squares to divide the image into.
Spectrum Panels 8 is a channel effect that separates the channel's output into 8 panels and resizes them based on the audio spectrum of the currently playing music.
Parameter 1: Adjusts the gain applied to the audio spectrum.
Parameter 2: Adjusts the initial starting size of each panel.
Fall is a transition effect that rotates forward the outgoing channel to reveal the incoming channel. It also darkens the outgoing channel to give the illusion of lighting within the 3D environment.
Gloom is a channel effect that dulls the highlights of the image.
Parameter 1: The radius of the effect.
Parameter 2: The intensity of the effect.
Bloom is a channel effect that applies a pleasant glow to the image.
Parameter 1: The radius of the glow.
Parameter 2: The intensity of the glow.
#25 - Vroom - effect like you're driving in a car
#25 - Broom - um.....same effect as #23 but for Japan users =P (sorry so lame)
#26 - Vacuum - this effect sucks.
#27 - Doom - end of the world effect
#28 - Loom - blanketing effect
#29 - Boom - makes video...um..."bass-ier"
#30 - Groom - cleaning like effect
ok. i'm done for now. got it out of my system. sorry for cluttering the thread. back to work...
Wipe Out H is a transition effect that performs a wipe transition that starts in the center and moves outwards horizontally.
Parameter 1: Adjust the edges of the Wipe effect between sharp and smooth.
Cut Strips H is a transition effect that segments both channels into vertical strips. Each strip performs a cut from the outgoing channel to the incoming channel as the transition progresses.
Parameter 1: Adjusts the number of vertical strips used for the transition.
Spinning Cube is a transition effect that displays both channels on the sides of a 3D spinning cube.
Parameter 1: Adjusts the speed at which the cube spins.
Hue Pass is a channel effect that only displays colours within a specified range. It can be thought of as the colour equivalent of an audio band-pass filter.
Parameter 1: Allows you to select the hue to display (the center hue).
Parameter 2: Allows you to adjust the range of hues to display around the center hue.
Ripple is a channel effect.
Parameter 1: The depth of the Ripple effect.
Parameter 2: The width of the Ripple effect.
Iris Warp is a transition effect similar to the Iris transition. However, the Iris Warp transition warps the outgoing channel around the incoming channel.
Lens Distortion is a channel effect that distorts the channel's output image.
Parameter 1: The amount of distortion.
Parameter 2: The offset for the red, green and blue channels.
Ripple Dissolve is a transition effect that warps and dissolves the output image of each channel.
Parameter 1: The amount of distortion.
Bad TV is a channel effect that produces output similar to that of a television with poor reception.
Parameter 1: The amount of distortion.
Parameter 2: Mix of the scan-lines.
Ripple RGB is a channel effect similar to the Ripple effect. However, Ripple RGB applies a separate ripple effect to the red, green and blue channels.
Parameter 1: The depth of the ripple.
Parameter 2: The width of the ripple.
Spectrum Line is a channel effect that overlays the channel with a coloured line representing the channel's audio spectrum.
Parameter 1: Gain to apply to the spectrum.
Parameter 2: The colour of the line.
Lens Distortion 2 is a channel effect that distorts the channel's output image.
Parameter 1: Controls the amount of distortion.
Parameter 2: Offsets the distortion in the red, green and blue channels.
Spinning Cube 2 is a transition effect similar to the Spinning Cube transition. The difference between the transitions is that Spinning Cube 2 slightly zooms out/in during the start/end of the transition.
Parameter 1: Controls the speed at which the cube spins.
Center Slide V is a transition that combines both the Slide and Wipe transitions. This is useful as it allows the center of the two channels (often the primary focus) to be visible throughout the entire transition.
Gradient Overlay is a channel effect that overlays a gradient on the currently playing video.
Parameter 1: Selects the preset gradient.
Parameter 2: Shifts the hue for that gradient.
Bad TV Switch is a transition effect that applies the Bad TV effect across the transition.
Parameter 1: Adjusts the amount of distortion.
Cartoon is a channel effect that makes your videos look like cartoons.
Parameter 1: Adjusts the width of the cartoon outlines.
Parameter 2: Adjusts the colour saturation.
Additive Blend is a transition effect that dissolves between a channel and the sum of both channels.
Fall Back SE is a transition effect similar to the previous Fall Back transition. However, the SE plug-in allows you to layer multiple cuts with the crossfader. Each time the crossfader moves away from an edge it triggers the Fall Back animation and captures the current image of that channel.
Parameter 1: The amount of rotation applied to the outgoing channel image.
Smash SE is a transition effect that smashes the outgoing channel into a number of pieces to reveal the incoming channel. The plug-in allows you to layer multiple cuts with the crossfader.
Parameter 1: Controls the number of pieces that the outgoing channel image is divided into.
Cube Rotate is a channel effect that displays the channel image on a rotating cube.
Parameter 1: Speed and direction of the rotation.
Parameter 2: Distance of the cube from the channel view point.
Spectrum Panels 3 is a channel effect that separates the channel's output into 3 panels and
resizes them based on the audio spectrum of the currently playing music.
Parameter 1: Audio spectrum gain.
Parameter 2: Adjusts the initial starting size of each panel.
Looks like that description is given for only the most recent one.
Psychedelic is a channel effect that applies a wave warp and cycles the hue of the channel's output.
Parameter 1: Adjusts the amount of warping.
Parameter 2: Adjusts the colour saturation.
Smash SE 2 is a transition effect that smashes the outgoing channel into a number of pieces to reveal the incoming channel. It differs from the Smash SE plug-in by using an additive blend to overlay the outgoing channel and the smashed channel's pieces do not fall away. The plug-in allows you to layer multiple cuts with the crossfader.
Parameter 1: Controls the number of pieces that the outgoing channel image is divided into.
TV Dream is a transition effect that distorts and dissolves between the incoming and outgoing channels.
Parameter 1: Controls the intensity of the distortion.
Halloween is a transition effect transitions between channels using one of four Halloween themed masks.
Parameter 1: Selects the mask to use.
Slide Strips V is a transition effect that slides alternating strips of the incoming and outgoing channels up and down.
Parameter 1: Controls the number of strips.
Squares is a channel effect similar to the Pixellate effect.
Parameter 1: Controls the pixellated area size.
Parameter 2: Controls the square size within that area.
Grid 3x3 Strobe is a transition effect that combines the Grid and Strobe transitions.
Parameter 1: Controls the strobe frequency.
Comic Call is a transition effect that combines a slide and wipe transition.
Two Up H SE is a transition effect designed for scratching and beat juggling. The transition displays both channels at once. When the crossfader is shifted to either edge, the corresponding channel is dimmed. When the crossfader moves from one edge to another, the previous channel's image is captured and an animation, that rotates and translates the image forward, is triggered.
Parameter 1: Controls the scale of each channel.
Iris SE is a transition effect similar to the Iris transition. However, Iris SE allows you to layer multiple cuts with the crossfader and freezes the outgoing channel.
if you do a twiddle, or a crab the screen goes bonkers with fader movement rings...
top shelf!
Spectrum Grid 3 is a channel effect that divides and displays the incoming audio spectrum in 3 bands.
Parameter 1: Adjusts the audio specturm gain.
Parameter 2: Adjusts the size of each block in the grid.
is there a way to keep the videos moving ? that way they are not in the same place. they just constantly move untill the crossfader is all the way over...
For the Bad TV - sounds interesting - will consider it.
Regarding "Comic Boxes" - I've been thinking of something similar - will have to see how well it works.
And for Slide Strips V - I guess what you're after is some sort of effect that looks like a slot machine.
Video Effect Request: Anaglyph aka 3D
Thanks
Deejay Callen
can we get some transtions like in ths mixed video
u see how the videos turn around. i would like to see something like that. but soemthing that keeps spinning around when ur in the middle of the crossfader...
check out 3:04 to 3:10
http://www.vdjbig.com/big/sc.html
Loving your work Nick! The quality of ME is awesome! Don't know why it took me so long to buy it!
Cant wait for 1.6 :)
Cheers!
http://www.vdjbig.com/big/sc.html
Do you know what program is he using Henry? :)
Smash is a transition effect that smashes the outgoing channel into a number of pieces to reveal the incoming channel.
Parameter 1: Controls the number of pieces that the outgoing channel image is divided into.
Hexagonal Pixellate is a channel effect that divides the channel into a number of coloured hexagons.
Parameter 1: Controls the size of the hexagons.